Line Magnetic LM805IA
The Line Magnetic 805iA uses single-ended triode 805 tubes and operate in pure Class A. It delivers 2x48W power. It has 3 unbalanced line inputs, 1 bypass input and 4, 8, 16Ω output groups. The rear-illuminated front panel meter is used to adjust the polarization of the tubes.
The use of high-quality components (Mundorf N-Cap capacitors, ALPS potentiometer) wired in the air for the most part is the guarantee of exemplary reliability. Its power and current capacity allows it to manage a very wide range of speakers. The use of the legendary triode 805 offers a listening to an unusual musicality.
- Single ended design
- Class A amplifier
- Point-to-point wiring
- High quality components
Input stage: 1x 6SL7 2x 6SN7
Drivers: 2x 300B
Power stage: 2x 805 « single-ended » et Pure Class A
Support des Tubes en stéatite
Hand-made construction with the finest point-to-point wiring
Bias control is accessible on top of the amplifier panel with true ampere meter.
Analog Inputs: 3 line inputs, 1 by-pass input Load impedance: 4/8/16Ω SoftStart and time-delay circuit. (30 seconds)
Specially designed EI transformer for power supply
Two EI output transformers with wide bandwidth are applied
ALPS volume control and Realcap capacitors are applied.
Metal and removable tube guard cage
Infrared Remote control
- Class A amplifier - 2x48W RMS
- THD: 1% (1kHz)
- Signal/Noise ratio: 87dB (Weighted A)
- Fréquence Responsive: (-1.5dB) : 10 - 50.000 Hz
- Sensitivity: 300 mV (Built-in Mode)
- Input Impedance: 100kΩ
- Load impedance for HP to connect: 4/8/16Ω
- 3x Line inputs RCA (pair)
- 1x Pré-in input
- 2x Screw terminals compatible with banana plugs
- 2x Fuses
- 1x Remote control
- 1x Detachable power cord
- 1x Manual
- Dimensions (WxHxD): 430 x 275 x 415 mm
- Weight: 42 Kg
The company LINE MAGNETIC was founded in 2005 by two brothers, both audiophiles who are passionate about tube electronics and notably the legendary American achievements of the 1950s. For many years, the company has become known throughout the world as the specialist in the repair and production of Western Electric, Altec, Jensen and other replicas of loudspeakers and electronics. Today, all drawings and designs are the result of a team of engineers audiophiles and experienced. The company has two factories in which all the products are made up of assemblies point-to-point wiring.
Know-how and pleasure of the senses
For many years, the company has become known throughout the world as the specialist in repairing and then replicating Western Electic loudspeakers and electronics.
Today Line Magnetic has its own line of products whose lineage with many products of legend is obvious.
Enjoy natural and performing sound
The Line Magnetic range is made up of amplifiers, sources and speakers, whose lineage with many legendary products is evident. Besides these productions, Line Magnetic also offers a whole range of components, loudspeakers, tube feeders, etc ... which are the delight of passionate audiophiles all over the world.
For many years, Line Magnetic has been known worldwide as a specialist in the repair and production of Western Electric, Altec, Jensen and other audio and speaker replicas. In addition to these productions, Line Magnetic also offers a whole range of components, speakers, tubes power supplies, etc ... which are the delight of passionate audiophiles around the world.